5-11
OPERATING YOUR VEHICLE
69TB-01E
Every time you press the engine switch,
the ignition mode changes as follows.
Manual transmission
68PH00322
CVT
57L31006
NOTE:
• CVT – If the gearshift lever is in any
position other than “P”, or if the knob but-
ton is pushed when the gearshift lever is
in “P” position the ignition mode cannot
be returned to LOCK (OFF).
• When selecting the ignition modes, the
information display in the instrument
cluster shows certain messages. Refer
to “Warning and indicator messages”
(P.4-16) for details.
If the master warning indicator light
blinks and the ignition modes cannot
be selected
Your keyless push start system remote con-
troller may not be sensed as being within the
interior workable area (refer to the related
explanation in this section). Try again after
checking that you have the remote controller
with you. If the ignition modes still cannot be
selected, the battery of the remote controller
may be discharged. To select an ignition
mode, you must then use the following
method:
63R40050
1) Without depressing the brake pedal
and the clutch pedal, push the engine
switch (1).
2) The master warning indicator light in
the instrument cluster blinks and the
message “PLACE KEY FOB ON
START SWITCH” appears in the infor-
mation display within about 10 sec-
onds. Touch the engine switch with
LOCK button side of remote controller
(2) for about 2 seconds.
(OFF)
(Audio equipment)
P
P
(OFF)
ONACCLOCK
(Audio equipment)
Gearshift lever in a
position other than
Gearshift
lever in
To Next Page
Loading...
Need help?
General
