5-12
OPERATING YOUR VEHICLE
69TB-01E
NOTE:
• If you still cannot select the ignition
modes, there may be some problem with
the keyless push start system. Contact
an authorized SUZUKI dealer or a quali-
fied workshop for an inspection of the
system.
• The immobilizer/keyless push start sys-
tem warning light will come on for about
5 seconds while the master warning indi-
cator light is blinking. In addition, the
information display in the instrument
cluster will show a message during this
time. Refer to “Warning and indicator
messages” (P.4-16) for details.
• You may customize the system to cause
the interior buzzer to sound once for
warning that remote controller is out of
sensing range. To incorporate this cus-
tomization, please contact an authorized
SUZUKI dealer or a qualified workshop.
• If the battery of the remote controller is
becoming discharged, the correspond-
ing message will appear in the informa-
tion display when you press the engine
switch to change the ignition mode to
ON. Refer to “Warning and indicator
messages” (P.4-16) for details. For
details on replacing the battery, refer to
“Keyless push start system remote con-
troller” (P.3-10).
Remote controller outside warning
When either of the conditions described
below is met, the system causes the
remote controller outside warning by
sounding the interior and exterior buzzers.
At the same time, the immobilizer/keyless
push start system warning light comes on
and the master warning indicator light
blinks.
• Any door is opened and then closed
while the remote controller is not inside
the vehicle and the engine is running or
the ignition mode has been changed to
ACC or ON by pressing the engine
switch.
• The remote controller is not inside the
vehicle when you attempt to start the
engine after changing the ignition mode
to ACC or ON by pressing the engine
switch.
69T050180
(1) Immobilizer/keyless push start sys-
tem warning light (blinks)
(2) Master warning indicator light (blinks)
NOTE:
• If the warning is given, relocate the
remote controller as soon as possible.
• Any attempt to start the engine will fail
while the warning is active. The mes-
sage appearing in the information dis-
play in the instrument cluster will also
indicate this condition. Refer to “Warning
and indicator messages” (P.4-16) for
details.
(1)
(2)
To Next Page
Loading...
Need help?
General
