Suzuki SWIFT 2024 User Manual

5-58
OPERATING YOUR VEHICLE
69TB-01E
The set vehicle speed adjustment incre-
ment can be changed through a customize
setting. Refer to “Setting mode of informa-
tion display” (P.12-8).
Setting to the current speed
1) Press “CANCEL” switch (4).
2) Accelerate or decelerate to the desired
speed.
3) Press the driving assist switch (2), the
set vehicle speed (b) and the speed
limiter indicator (c) illuminate in green
(active state). The current vehicle
speed is set as the set vehicle speed.
Canceling/resuming control
• To cancel the speed limiter, press driving
assist switch (2) or “CANCEL” switch (4).
Set vehicle speed (b) and speed limiter
indicator (c) will illuminate in white
(standby condition).
• To resume the previously set vehicle
speed, pull up the “RES +” / “–” switch
(3). The set vehicle speed (b) and speed
limiter indicator (c) will illuminate in
green (active state).
Speed limiter with traffic sign rec-
ognition
When traffic sign recognition function is
enabled and the speed limiter is activating,
if a speed limit sign is detected, the
detected speed limit will be displayed with
an up/down arrow in the information dis-
play. The set vehicle speed can be
increased/reduced to the detected speed
limit by pulling up the “RES +” / “–” switch
(3) and hold it in the “RES +” position or
pulling down the “RES +” / “–” switch (3)
and hold it in the “–” position.
When the set vehicle speed is lower
than the detected speed limit
• Pull up the “RES +” / “–” switch (3) and
hold it in the “RES +” position.
When the set vehicle speed is higher
than the detected speed limit
• Pull down the “RES +” / “–” switch (3)
and hold it in the “–” position.
NOTE:
The speed limiter with traffic sign rec-
ognition may not operate properly
when
As the speed limiter with traffic sign recog-
nition may not operate properly in situa-
tions where the traffic sign recognition may
not operate or cannot detect signs cor-
rectly, when using this function, make sure
to confirm the actual speed limit.
In the following situations, the set speed
may not change to the detected speed limit
by pressing and holding the “RES +” / “–”
switch (3):
• When the detected speed limit is the
same as the set speed
• When the detected speed limit is outside
of the speed range which the speed lim-
iter system can operate

Suzuki SWIFT 2024 Specifications

General

Brand	Suzuki
Model	SWIFT 2024
Category	Automobile
Language	English