5-57
OPERATING YOUR VEHICLE
69TB-01E
Exceeding set vehicle speed
The set vehicle speed can be exceeded
temporarily by quickly depressing the
accelerator pedal all the way down. While
the vehicle speed is exceeded, the set
vehicle speed (b) will be displayed as fol-
lows.
69T050540
If the accelerator pedal is released to
return below the maximum speed, the
function will restore.
NOTE:
• When the accelerator pedal is
depressed slowly, the vehicle speed may
not exceed the set vehicle speed. To
exceed the maximum speed, depress
the accelerator pedal all the way down
quickly or press driving assist switch (2)
or “CANCEL” switch (4) to cancel the
speed limiter temporarily.
• If the speed limiter cannot prevent the
vehicle from exceeding the maximum
speed in such cases as when going
down a steep hill, or under excessive
acceleration, the set vehicle speed (b)
will be displayed as follows and the
buzzer will sound.
69T050530
In this case, decelerate to return below
the maximum speed using the brake
pedal.
Adjusting the set vehicle speed
Adjusting the set vehicle speed using
the switches
69T050420
(1) Increase set vehicle speed
(2) Decrease set vehicle speed
Short press adjustment:
Press the switch
Long press adjustment:
Press and hold the switch until the
desired set vehicle speed is
reached.
The set vehicle speed will increase or
decrease as follows:
• Short press adjustment:
By 1 km/h (0.6 mph) or 1 mph (1.6 km/h)
each time the switch is pressed.
• Long press adjustment:
Increases or decreases in 5 km/h (3.1
mph) or 5 mph (8 km/h) increments con-
tinuously while the switch is pressed and
held.
To Next Page
Loading...
Need help?
General
