10-26
EMERGENCY SERVICE
69TB-01E
6) Install the new wheel and replace the
wheel nuts with their cone shaped end
facing the wheel. Tighten each nut
snugly by hand until the wheel is
securely seated on the hub.
82K132
Tightening torque for wheel nut
100 Nm (10.2 kg-m, 74.0 lb-ft)
7) Lower the jack and fully tighten the nuts
with a wheel wrench (if equipped) in
numerical order as shown in the illus-
tration.
69T100080
Return the spare tyre (if equipped) back
into the luggage compartment in the
reverse order of removal and tighten its
bolt (6) clockwise as shown in the above
illustration.
WARNING
Use genuine wheel nuts and tighten
them to the specified torque as soon
as possible after changing wheels.
Incorrect wheel nuts or improperly
tightened wheel nuts may come
loose or fall off, which can result in
an accident. If you do not have a
torque wrench, have the wheel nut
torque checked by an authorized
SUZUKI dealer or a qualified work-
shop.
(6)
NOTICE
Make sure that the spare tyre is fixed
securely on the floor. Loosely fixed
tyre may cause noise during driving
and damage paint on vehicle body.
To Next Page
Loading...
Need help?
General
