10-30
EMERGENCY SERVICE
69TB-01E
63J349
6) Hold the bottle (2) with bottom upwards
and pump the bottle to fill the entire bot-
tle contents (sealant) into the tyre.
Thereafter pull off the filler hose and
firmly screw the valve insert into the
tyre valve again. If the valve insert is
dirty or lost, use the enclosed spare
valve insert.
81PN120
7) Screw the air hose (10) of the compres-
sor (1) to the tyre valve (8). Fit the
power plug (11) to the accessory
socket. Start the engine. Switch on the
compressor. Inflate the tyre to the
required air pressure.
If the air pressure still cannot be reached
the required air pressure, the tyre may be
severely damaged. In this case, the flat
tyre repair kit cannot provide the neces-
sary seal. Consult an authorized SUZUKI
dealer or a qualified workshop or a road-
side assistance service.
NOTE:
If over inflated, deflate air by loosening the
screw of the air hose.
8) Make a short drive immediately after
inflating to the required air pressure.
Drive carefully with a maximum speed
of 80 km/h (50 mph).
WARNING
Do not stand by the tyre, when inflat-
ing. It can burst.
NOTICE
Do not operate the compressor for
longer 10 minutes without cease. It
can cause overheating of the com-
pressor.
(1)
(8)
(11)
(10)
10 min. Max.
required
air pressure
To Next Page
Loading...
Need help?
General
