10-31
EMERGENCY SERVICE
69TB-01E
81PN249
9) Affix the enclosed speed restriction
label in the driver’s field of view, and
carry on driving carefully to the nearest
an authorized SUZUKI dealer or a qual-
ified workshop or a tyre repair shop.
10)After 5 km (3 miles) or 10-minute run-
ning, check the tyre pressure with the
pressure gauge of the compressor. If
the air pressure indicates more than
130 kPa (1.3 bar), the emergency
repair is completed. But, if the air pres-
sure indicates less than the required air
pressure, correct the tyre pressure to
the required air pressure. If the tyre
pressure has dropped below 130 kPa
(1.3 bar), the flat tyre repair kit cannot
provide the necessary seal. Do not use
the tyre and consult an authorized
SUZUKI dealer or a qualified workshop
or a roadside assistance service.
Using compressor to inflate a tyre
1) Place the vehicle on level, hard ground.
Set the parking brake firmly and shift
into “P” (Park) if your vehicle has a
CVT, or shift into “R” (Reverse) if your
vehicle has a manual transmission.
2) Take out the compressor.
3) Unscrew the valve cap from the tyre
valve.
4) Connect the air hose of the compressor
to the tyre valve.
5) Connect the power plug of the com-
pressor to the accessory socket. For a
manual transmission vehicle, shift from
“R” (Reverse) into “N” (Neutral). Start
the engine. Switch on the compressor.
Inflate the tyre to the required air pres-
sure.
WARNING
Do not affix the speed restriction
label to the airbag cover. Also do not
affix it to the warning light indicator
or to the speedometer.
WARNING
Check the tyre pressure and confirm
the completion of the emergency
repair after 5 km (3 miles) or 10-min-
ute of running.
NOTICE
Have the tyre renewed at the nearest
an authorized SUZUKI dealer or a
qualified workshop. When reusing
the sealed tyre, consult a tyre repair
shop.
The wheel can be reused after wiping
sealant off completely with cloth in
order to prevent rust, but the tyre
valve and tyre pressure monitoring
system (TPMS) sensor (if equipped)
must be renewed.
Dispose of the sealant bottle at an
authorized SUZUKI dealer or a quali-
fied workshop or in accordance with
your regional codes and practices.
After using the sealant bottle, replace
it with a new bottle from your an
authorized SUZUKI dealer or a quali-
fied workshop.
NOTICE
Do not operate the compressor for
longer than 10 minutes. It can cause
overheating of the compressor.
To Next Page
Loading...
Need help?
General
