The window slider kit has been designed to fit most standard vertical and horizontal
window applications,however, it may be necessary for you to modify some aspects of the
installation procedures for certain types of windows. The window slider kit can be fastened
with screws.
Note: If the window opening is less than the minimum length of the window slider kit, cut
the end without the hold in it short enough to fit in the window opening. Never cut out the
hole in window slider kit.
WINDOW SLIDER KIT INSTALLATION
1:Parts name:
A) Panel (Second slider may not supplied)
B) Panel with one hole
C) Screw to lock window kit in place
2: Assembly:
Slide Panel B into Panel A and size
to widow width. Windows sizes vary. When
sizing the window width, be sure that the window kit assembly is free from gaps from gaps
and/or air pockets when taking measurements.
3.Lock the screw into the holes that correspond
With the width that your window requires to ensure that there are no gaps or air pockets in
the window kit assembly after installation.
To Next Page
Loading...
