● Select the required fan speed by pressing the button.
Two speeds are available: High / Low.
● Water is removed from the air and collected in the tank.
● When the tank is full, the appliance shuts down and “ ” (full tank) appears on the display.
The tank cap must be extracted and emptied. Run off all water left into a basin. When all the
water has been drained, put the cap back in place.
● When the tank has been emptied, the appliance starts up again.
N.B.: - When operating in very cold rooms, the appliance defreezes automatically, momentarily
interrupting normal operation. “ ” appears on the display. During this operation, it is
normal for the noise made by the appliance to change.
- In this mode, you may have to wait for a few minutes before the appliance starts giving out
hot air.
- In this mode, the fan may operate for short periods, even though the set temperature has
already been reached.
SETTING THE TIMER
This timer can be used to delay the appliance start up or shut down, this avoids wasting
electricity by optimizing operating periods.
Programming start up
－
Turn on the appliance, choose the mode you desire, for example cooling, 24
℃
and high
fan speed. Turn off the appliance.
－
Press the button, the screen will display 1-24 hours.
－
Press several times until the corresponding time is displayed. Wait about 5 seconds, the
timer will be active, then “Timer” symbol is displayed on screen.
－
Press again the “ ”button, the timer will be canceled, and the ”Timer” symbol will
disappear from screen.
To Next Page
Loading...
