⚫ Remove the lint filter by putting it up and open
the lint filter.
⚫ Clean lint, fiber and cotton raveling by hand or
with a soft piece of cloth.
⚫ Close the lint filter and place it back into its
housing.
⚫ A layer can build up on the filter pores that can
cause clogging of the filter after using
\the dryer for a while. Wash the lint filter with
warm water to remove the layer that builds up on
the lint filter surface. Dry the lint filter completely
before reinstalling it.
⚫ The lint trap has to be cleaned frequently.
Water container collects all the water from condenser.
Water container need to be emptied after every drying
cycle. If the water container is full, an active program will
break off automatically, the light will come on and the
buzzer sounds. In order to continue the program, the
water container must first be emptied
1. Pull out water container.
2. Tip water into pool.
3. Put the water container in dryer.
4. Press the Start/Pause button.
To Next Page
Loading...
