In the movement process, this device is used for induction
humidity of clothing, it means that it must be carried on cleaning.
Major cause of clean is must scour out the calcium oxide boiler
which on the sensor surface up. Clean the sensor in the tumbler
(See picture).
Lint and fiber that could not be captured by the lint filter are blocked in the
filter drawer behind the cover. Clean the filter drawer after each drying
process. There is a two-level filter in
⚫ the filter drawer. The first level is the filter drawer
sponge and the second level are the filter cloth.
Press the button to open the cover.
⚫ Unlock the fixer.
⚫ Pull out the filter drawer.
⚫ Clean lint, fiber and cotton raveling on the filter
cloth by hand or with a soft piece of cloth.
⚫ When you notice a layer that may lead clogging on
the filter cloth, please clean the layer by washing
in warm water. Let the filter cloth dry thoroughly
before installing back the filter drawer.
⚫ Wash the filter drawer sponge by hand to remove
the fiber and lint on the surface. After washing the
sponge. squeeze it by hand and remove the
excess water. Well-dry the sponge before storing
it.
⚫ Clean the lint accumulated on the fins of the
evaporator located behind the filter drawer with a
vacuum cleaner or a soft brush. You can also clean
by hand provided that you wear protective gloves.
⚫ It is recommended to clean it at least twice every
month.
To Next Page
Loading...
