Sven PS-720 - Wired (LINE IN) and TWS Connection; Reset and Specifications

ENG
6
2.1 Multimedia
Speaker System
THE USE IN THE WIRED MODE (LINE IN)
• Speaker system can be used as an external device for amplifying any audio source
witha3.5mm output mini-jack. Connect a cable mini USB, plug 3.5 mini-jack to the audio input
AUX c. Turn the speakers to the LINE IN mode — press the MODE button k several times until
«LINE» appears on the display.
Connecting an additional speaker (only for models with production date from 04.2021)
For models PS-720/PS-750 you can connect an additional speaker (Bluetooth mode only):
• Turn both speakers into Bluetooth mode.
• Connect the signal source to one of the speakers via Bluetooth (the second column should be
insearch mode).
• On another speaker press and hold button DEL(TWS) u.
• If two speakers are successfully connected between themselves, the inscription TWS will glow
constantly.
Reset
To reset the settings, long press the EQ button until «RES» appears. Then press button
h
onthe RC or button l on the front panel. Settings will reset.
TECHNICAL SPECIFICATIONS
Parameter, measurement unit Value
Frequency response, Hz 45–22 000
Output power (RMS), W 80 (2 × 40)
Speaker diameter, mm Ø 32 + Ø 145
Battery capacity, mA*h 4 400 (2 pcs)
Power supply, V USB ⎓ 5
Weight, g 5 200
Dimensions, mm 230 × 640 × 260
Notes. Technical specications given in this table are supplemental information andcan-
not give occasion to claims. Technical specications and package contents aresubject
to change without notice due to the improvement of SVEN production.