Sven PS-720 - Operation and Connectivity; Remote Control Functions; Battery Charging; Operation Modes

ENG
4
2.1 Multimedia
Speaker System
n LIGHT: switching backlight modes (short pressing); Turning on/o the backlight (long pressing).
o Display.
p MIC PRI: mute with a connected microphone.
q EQ: EQ mode switch button (short pressing); Return to default settings (long pressing).
r FM-/
: previous track (short pressing in Player and Bluetooth mode); Navigation onthetrack
(long pressing in Player mode); Previous track/station (in Radio mode); Search forastation
withalower frequency (in Radio mode).
s IR receiver.
t FM+/
: next track (short pressing in Player and Bluetooth mode); Navigation on thetrack
(long pressing in Player mode); Next track/station (in Radio mode); Search for a station withahigh-
er frequency (in Radio mode).
u DEL(TWS): FM station deletion (long pressing in Radio mode); Connecting an additional
speaker (long pressing in Bluetooth mode).
v ECHO +/-: microphone echo adjustment knob.
Remote control
a MODE: switching modes button: Bluetooth/Radio/Player/
LINE IN (short pressing); ON/OFF the service signals (long press-
ing).
b LIGHT (MUTE): switching backlight modes (short pressing);
Mute (long pressing).
c REP: disconnect from the device (long pressing Bluetooth
mode); Repeat mode selection button (in Player mode).
d EQ: EQ mode switch button.
e VOL-/+: volume up/down.
f
, CH-: previous track (in Player and Bluetooth mode); Previ-
ous station (in Radio mode).
g
, CH+: next track (in Player and Bluetooth mode); Next sta-
tion (in Radio mode).
h
, AUTO SCAN: Play/Pause button (in Player and Bluetooth
mode); Start/Stop auto scan (long pressing in Radio mode); Mute
(short pressing in Radio and LINE IN mode).
i FM-/+: frequency changeа (in Radio mode).
j 0-9: numeric pad for entering track number (in Player mode)
or number track/station (in Radio mode).
CONNECTION AND OPERATION
Attention! The built-in battery must be charged completely prior to the application.
Speaker system battery charging
• Connect speaker system to a USB port of PC or USB charger using type-C to USB cable (included).
During battery charging the indicator g is red. Indicator g goes out when the battery ischarged.
• The battery is used in the speaker system as an integral part of the device, therefore do nottry
toextract or replace it, because this can result in the warranty cancellation or the device damage.
OPERATION MODES
Bluetooth mode
• Wireless data transfer via the Bluetooth protocol enables to connect speaker system to com-
patible devises. Maximum radius of action of data transfer is 10 m. Such obstacles as walls
orother electronic devices can interfere with the signal transfer.
Fig. 2.