English version
13
Setting the Internet Provider (ISP)
Prior to setting the provider, make sure that the Internet connection is active without the Sweex Broadband Router. If the modem without the router
does not have an Internet connection, setting the router would be pointless. After all, the modem establishes the Internet connection and the Sweex
Broadband Router forwards this existing Internet connection to one or more computers in your network.
We recommend using the Configuration Wizard in order to set the router. If your provider cannot be set using the Configuration Wizard, contact your
provider for the correct settings and enter them manually. The instructions can be found later in this manual.
These settings need to be configured in your router only once. Regardless of the number of computers you connect to the router, the following
settings only need to be done on one computer. That is because the settings are not stored on the computer, but on the router.
Setting the Internet Provider by means of the Configuration Wizard
In the start menu of this CD-ROM, click on Configuration Wizard in order to set your Internet Provider.
Wireless settings and security
We always recommend entering these settings with a computer connected to the Sweex Broadband Router by means of a cable. This is because you
will lose the wireless connection with the Sweex Broadband Router while storing these settings.
Left in the column, under “Wireless" click on “Basic Settings”.
To Next Page
Loading...
