Swegon GLOBAL PX - 9.0 Parameters and Commissioning Sheet; 9.1 Main Parameters After Commissioning

63
Operation and maintenance instructions
9.0 Parameters/Commissioning Sheet
Please enter all settings specic to your installation in this table. Please keep this document at hand when
there is a need to contact us to report a problem.
9.1 MAIN PARAMETERS AFTER COMMISSIONING
1 GLOBAL model:
2 Operating mode:
O Constant Airow
O Demand control
O Constant Torque
O Constant pressure
3 Constant Airow:
K1 = O [m³/h] O [l/s]
K2 = O [m³/h] O [l/s]
K3 = O [m³/h] O [l/s]
4 Constant Torque:
K1 = % Torque
K2 = % Torque
K3 = % Torque
5 Demand control:
Vmin = V
Vmax = V
m³h / %TQ
Vmin = O [m³/h] O [l/s]
m³h / %TQ
Vmax = O [m³/h] O [l/s]
% on K3 = %
6 Constant pressure:
Assignment Pa = O [V] O [Pa]
% on K3 = %
7 Ratio exhaust / supply: %
8
Pressure alarm
(not for pressure
control mode)
Activated?
O Yes O No
O Automatic O Manual
Setup Initialisation:
Supply: O [m³/h] O [l/s] O [Pa]
Exhaust: O [m³/h] O [l/s] O [Pa]
9 If KWin option: T° KWin = °C
10 If KWout option T° KWout = °C
11 If IBA option: T° IBA = °C