EasyManua.ls Logo

swepac F 50 - Before Starting Gx120 Engine; Starting; After Starting; Stopping

swepac F 50
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10
F 50
F50 / F75
Doc: 101425E-GB 1406
Oil level
Off
On
Engine power switch
Off On
Fuel cock
Closed Open
Choke
Full RPM
Idle
Throttle lever
BEFORE STARTING GX 120 ENGINE
See Daily Checks on page 8.
STARTING
Switch the engine power switch to “on”. Open the fuel cock.
Switch the throttle lever to 1/3 of full RPM.
Adjust the choke. If the engine is cold, close the choke com-
pletely. Do not use the choke if the engine is warm or if the
air temperature is high.
Start by pulling the starting handle. Pull it rst until the
mechanism engages. Then pull it hard and fast.
AFTER STARTING
Switch the throttle lever to idle.
Open the choke gradually.
Run the engine warm for around 5 minutes.
STOPPING
Switch the engine to idle and let it run for a few minutes.
Switch the engine power switch to “off”.
Close the fuel cock.