Swift 2004 User Manual

SWITCHING ON THE REFRIGERATOR
(N80)
• It is recommendable to clean the inside of
the refrigerator before you switch it on.
• Let the refrigerator cool for at least eight
hours before you place food in it for the
first time.
• The freezer compartment should be cold
one hour after switching on the
refrigerator.
Igniting and starting your refrigerator
Automatic ignition (N80E)
A.
The refrigerator can be powered by the
mains (230V), direct current (12V) or liquid
gas. Select the energy source that you
want by means of the energy source
selector switch (A). The switch has four
settings:
• direct current (DC)
• mains supply
• gas
• switched off
B. The thermostat controls the refrigerator
temperature when the refrigerator is
powered from the mains (230V). Position
5 is the coldest temperature setting.
C. The gas control button controls the
refrigerator temperature when the
refrigerator is powered by gas. Position 5
is the coldest temperature setting.
D. The flame meter shows whether the flame
is burning. The flame is burning when the
meter comes into the green area.
Electrical operation
The refrigerator can be powered by
electricity in two ways:
• 12 V DC: Set the energy source selector
switch (A) to
• the refrigerator will now be powered by
the battery of your car or camper.
Important!
- Always use the gas connection or mains
voltage to start up the refrigerator for
the first time and to cool it. Powering
from the battery of your vehicle is
suitable only for maintaining the
temperature of the refrigerator and its
contents once it has been refrigerated.
- When powered by a vehicle battery the
refrigerator works without temperature
control (i.e. constant operation).
• Mains voltage (230 V): set the power
selector switch (A) to
• Set the temperature by means of the
thermostat, rotary switch (B). Position 5 is
the coldest temperature setting.
Powering with gas
Warning!
- Flammable material must be kept away
from the refrigerator.
- For selection of gas type, see the
information plate inside your refrigerator.
- For the pressure regulator model, see
the information plate inside your
refrigerator.
- The type of gas container and its
location must be in compliance with the
most recent regulations. Ensure that the
unit is installed in a location with good
ventilation and make sure that the
ventilation openings in the gas container
storage location remain open.
- The changing of the gas container must
be done outside in the open air and out
of reach of any possible sources of
ignition.
Fitted Equipment
84
A = Energy source selector switch
B = Electric thermostat
C = Gas control button
D = Flame meter
AB DC

Swift 2004 Specifications

General

Brand	Swift
Model	2004
Category	Motorhomes
Language	English