Swiss Timing StartTime V - Independent Operation Mode

Page 10 3481.560.02 Version 1.2
Independent operation
It is possible to use the StartTime V without or SMU.
In this case, it is only possible to carry out starts and false starts with the START button of the STV.
1. Turn the unit ON by pressing the key (5sec.).
2. Select sport (Athletics, Swimming, Speed Skating or Custom).
3. After 5 seconds, the sport will be automatically selected based on the last use.
4. Adjust the OUTPUT VOLUMES on the StartTime V to an appropriate level
Speaker Int.
Speaker Ext.
Headset
Line Out
5. Press the key before start and check if MANUAL READY is written on the StartTime V display.
6. Press the key for the start.
7. If a false start is to be announced, press the key again within time selected in False Start Setup Timeout
Timeout can be adjusted on the main unit in Setup False Start Setup Timeout .
Repeat can be adjusted on the main unit in Setup False Start Setup Repeat .
False Start Sound can be adjusted on the main unit in Setup False Start Sound .
The false start Timeout signal is only functional if
Setup
is selected from
1
to
90
seconds.
Select
False Start Setup
to
OFF
if false signal is not used.
The Repeat false start signal can be adjusted from
1x
to
5x
. Select
False Start Setup
to
OFF
if false signal is not used.