If you require any on site technical assistance including
repair or maintenance queries please call 01524 772400
or email technical@swsuk.co.uk
Control unit set up instructions are provided
in the control panel accessory box along with
the control unit and you can also access them
digitally using this QR code or link:
www.sws.co.uk/easysetup
12. TECHNICAL ASSISTANCE
Internal Fitting
Fit optional 45 degree lid. A slot may have to be cut into the lid to pass over the override eye.
11. COMMISSIONING
Final Checks
i. Remove any protective plastic coverings
ii. Wipe curtain & guides with damp cloth
iii. Touch-up any small scratches
iv. Check all electrical & operating equipment is installed
and functioning correctly (especially the safety edge) and
complete CE marking label and paperwork
v. Check direction handle needs winding to open door and fit
appropriate label supplied to crank handle.
vi. If the door is fitted externally apply a bead of silicone around
the box edge to prevent water ingress.
N.B. Check the front of the curtain to make sure that it is not
rubbing on the fascia etc.
The manual override will not function after the door is operated,
by remote control, until the power to the motor has ‘timed out’.
This will take a few moments to occur.
If you wish to demonstrate the manual override immediately after
opening the door press either the stop button on the handset or
simulate a power cut by switching off the power to the Control
unit.
If a low level external override is fitted or the door is fitted
externally remind customers to keep the override handle in a
convenient place (not in the garage if no other way in!)
Upon completion it is your responsibility to train the customer
how to operate the door correctly and safely and provide them
with the operating and maintenance instructions supplied.
To Previous Page
Loading...
Need help?
General