Installation
11
Tyre levers
2. Prepare your Swytch motor wheel
Fit your Swytch motor wheel with a
new tyre and inner tube. For support
and advice on which tyre you should
use visit support.swytchbike.com.
If you don’t have a new tyre, use the
tyre and inner tube off the wheel
you just removed from your bike.
Pump up the tyre to the
manufacturer’s suggested tyre
pressure. This is printed on the
sidewall of the tyre.
If you have disc brakes, remove the
six screws and plastic spacer from
the motor wheel. Move the disc
rotor from your old wheel onto your
Swytch motor wheel.
2.1 2.2
2.3 2.4
8mm
Note
Tighten the screws with 2-3 Nm of
torque. If you’re unsure about
working on your brakes, visit
swytchbike.com/manual/3nm/ for
support.
Use the existing screws and
hardware you have. The screws
should have an 8mm thread length.
To Next Page
Loading...
