Installation
26
2. Find the correct spacers size (optional)
2.1
Without a spacer, the bracket has a
31.8mm diameter.
If the bracket is loose on the
handlebar, find a set of spacers to
get a tight fit. There should be a
small gap between the two spacers,
as shown in the diagram below.
22.2mm
25.4mm
26mm
Spacer Options:
Too tight Too loose Perfect fit
1.
Place the mount under the handlebar
1.1 Position the mount on the centre
of the handlebars, horizontal to the
floor.
Route any brake or gear cables
behind the mount. Check your
brakes still work as normal.
!
To Next Page
Loading...
