Brompton Specific
37
4.
Mount Placement
1.1
1.2
When securing the handlebar mount
and bracket to a Brompton, please
make sure that it’s positioned with
the Power Pack facing the seat
posts, as shown in this picture. This
allows the Brompton to fold without
damaging the Power Pack.
Position together the lower and
upper bracket halves, placing the
spacers inside if they are required.
To secure the mount in place screw
the two bracket halves together
using a 3mm Allen key. Make sure
both halves are even.
Note
Tighten the screws with 2-3 Nm of
torque. If you’re unsure about this,
visit swytchbike.com/manual/3nm/ for
support.
To Next Page
Loading...
