16
E
11. List of the main commands
Selection and configuration Interrogation
CHA+ / CHA- Change measurement direction ? Current value?
CHA? Measurement direction?
FCT0 ...9...A...F Assign «favourite» function FCT? «favourite» function active?
MM / IN Change measurement unit UNI? Measurement unit active?
KEY0 / KEY1 Lock / unlock keypad KEY? Keypad locked?
MUL [+/-]xxx.xxxx Modify multiplication factor MUL? Multiplication factor?
PRE [+/-]xxx.xxx Modify preset value PRE? Preset value?
STO1 / STO0 Activate / de-activate HOLD STO? Status of HOLD function?
ECO1 / ECO 0 Activate / de-activate economic mode ECO? Current economic mode
LCAL dd.mm.yy Modify last calibration date LCAL? Date of last calibration?
NCAL dd.mm.yy Modify next calibration date NCAL? Date of next calibration?
NUM x...x (up to 20chars) Modify the instrument number NUM? Instrument number?
MIN /MAX /DEL /NOR Selecting MIN, MAX, Delta, Normal mode MOD? Active mode (MIN, MAX, Delta or Normal)?
CLE Re-initialisation of MIN, MAX or Delta SET? Main instrument parameters?
UNI1 / UNI0 Activate / de-activate change of units ID? Instrument identication code?
OUT1 /OUT0 Activate / de-activate contin. data transmission
ANA ON / ANA OFF Activate / de-activate the analog scale
FACT1/FACT5/FACT10 Range of the analog scale
Maintenance functions
PRE ON / PRE OFF Activate / de-activate Preset function BAT? Battery status (BAT1 = OK, BAT0 = low battery)
PRE Recall Preset OFF Switch-o (wake up using a button or RS)
SET Zero reset RST Re-initialisation of the instrument
RES1 / RES2 Change of resolution SBY Put instrument in stand-by (SIS)
VER? Version No. and date of rmware
SBY xx xx number of minutes before stand-by
BT0/BT1 Activate / de-activate Bluetooth
®
module MAC? Bluetooth
®
MAC address ?
BTRST Clear pairing information
To Next Page
Loading...
Need help?
General
