26
11. INSPECTION AND MAINTENANCE BEFORE RIDING
INSPECTION AND MAINTENANCE OF BATTERY
y This scooter is equipped with a maintenance-free type battery, so it is unnecessary to check and add
electrolyte. Have your scooter checked by SYM Authorized Dealer or Franchised Dealer should any
abnormality is found.
y Remove the battery terminals and clean if there are dirt and corrosion on them.
Negative
Positive
NOTE:
Battery removal procedures are as follows:
y First turn ignition switch “OFF,” then remove the negative cable screw and disconnect the negative
cable, then remove the positive cable screw and positive cable and remove battery.
y To install the battery, reverse the procedures of the removal of the battery.
CAUTION:
y Keep the scooter’s battery clean. If the battery’s posts are eroded and/or are covered with white
powder clean them with warm water.
y If there is obvious erosion on the battery terminals, disconnect the battery cables and remove the
erosion with a steel brush.
y If the battery needs to be replaced, replace with a same closed-type battery (Maintenance-Free).
CAUTION:
y This scooter uses a sealed type (Maintenance-Free) battery. Never remove the battery caps.
y In order to prevent electrical leakage and self-discharge when the battery sits idle for long periods
of time, remove the battery from scooter and store it in a well-ventilated and dimly lighted area. If
the battery is to be kept on the scooter, disconnect the battery’s negative cable.
y Replace the battery cables after cleaning and apply a thin coat of grease to the battery terminals.
To Next Page
Loading...
