Sym LZ40W1-EU - Coolant System Maintenance; Coolant Level Inspection and Filling

38
Coolant Level Inspection / Filling
This scooter is filled with high quality coolant that is designed for the cooling system in the factory. It
contains a 50% solution of ethylene glycol based antifreeze. Position the scooter on level ground and in an
upright position. The coolant inspection window ○A is located under the left floor panel. The coolant level
must be between the “FULL” ○a and “LOW” ○b marks. Top up the coolant carefully when the level is at the
“LOW” mark.
 Pull up the tip of the left floor panel mat ○A to remove it.
 Wrap a screwdriver that covered with a protective cloth, and insert into the hole to open the
maintenance cap ○A .
 Open the reserve tank cap ○A to fill in coolant.
○A
○A
○A
○a
○b
○A
 Reverse the above steps to restore.