Product
Features
1.
Low-voltage Protection:
When the four indicator lights on the
drone start flashing , it means that the
drone's battery power
is
low. At this time,
please control the drone return. The
drone
will automatically slow down when
it
is
short of power.
2.
Over-current Protection:
When the drone encounters direct impact
from a foreign object, or
is
obstructed, or
the
blades are not rotating, the drone will
go into the over-current protection mode.
3.
Level Calibration Function:
Place the drone on a level surface and at the
same time push both
left and right joysticks
to the
lower right corners for 2 to 3 seconds;
the indicator
lights on the drone will blink
rapidly,
and they will return to solid status
after about 2 to 3 seconds. The
level
calibration
is
successful.
4.
High/Low Speed Function:
Low speed
is
set by default when first
powered-on. To switch to high/low speed,
press the right joystick fast.
It
is
switched into
high speed mode when you hear two
"beep"
sounds from the remote control; press the
right joystick fast again
while on high speed
mode and then you hear one
"beep" sound
from the remote
control, then it
is
switched
back into
low speed mode.
-5-
To Next Page
Loading...
