•Push
the left joystick (throttle)
on
the
remote
control up to the farthest position
and then
pull down to the farthest position.
When the remote
control issues a long
beep sound, it means the frequency and
defining forward direction functions are
completed.
2.
Calibration for the definition of the front:
When the drone encounters a direct impact
with
an
object
in
the headless mode, if only
the set direction has been changed,
it
is
only
required to push both the left and right
joysticks to the bottom left corners
simultaneously after placing the flying
direction of the drone
in
the correct position.
When the indicator of the drone turns to
solid
after slowly flashing for 3 seconds, it indicates
the
ca
li
bration
is
complete.
3.Toggling
between headless function and normal function:
After the drone
is
matched with the
corresponding frequency, the drone
would
be
in
normal pattern by default. At this time the
indicator
light
on
the drone would
be
on
. After
pressing
in
on
the right joystick of the remote
control for 2 seconds, the remote control would
make a sound
of
"beep, beep, beep" to show
that it has entered into the
headless mode.
Pressing
in
on
right joystick for 2 seconds then
a
long sound
of
"beep" would be heard to show
an
exit of such mode. (When under the
headless mode, four indicator lights
on
the
drone
flash slowly once every four seconds)
Under the
headless mode, the operator does
not need to differentiate the head position of
the drone, and
only needs to control the
drone's direction front/back/
left/right by using
the right joystick direction
on
the remote
control.
-7-
To Next Page
Loading...
