-4-
1. Flight preparation
Step1: Turn on the transmitter.
Preperation for Flight
2.Arming Motors
Step2 :Turn on the drone
Step 3: Move the left stick (throttle) fully up and
after fully down. The drone indicator lights will
turn solid (glow) indicating the drone is ready to
fly.
Method 1:
Move the left stick (throttle) fully up, after let it
come back to the middle and the motors will
start spinning.
Method 2:
Push both sticks at the same time (left stick to
the bottom-right corner and the right stick to the
bottom-left corner) and hold for 1 second and
the motors will start spinning.
Method 3:
Place the drone on a flat level surface and after
press the B button. The drone will take-off, and
hover at the preset height.the motors will start
spinning.
1. If the drone flies out of control range, the drone indicator lights will
start flashing slowly and after the drone will slowly descend.
2. If the transmitter turns off or the transmitter battery runs low, the
drone will slowly descend. Turn on the transmitter again, re-pair the
unit and continue to fly.
To Next Page
Loading...
