Symbol ES3000 - Creating a QOS In-Profile Action

ES3000 Advanced Concept Guide
8-4
the destination IP address as 192.168.2.2 and the destination layer 4 port as 80, would apply only to
port 80 traffic bound for that IP address.
The format for the CLI command is
diffserv classifier <id> [src-mac <MAC>][dst-mac <MAC>]
[vlan-id <vid>] [dscp <value>][protocol <pro-num>]
[src-ip <ip>][dst-ip <ip>] [src-port <port>][dst-port <port>[
8.2.2 Creating a QOS In-Profile Action
If a QoS policy has an in-bound profile action, that action will apply to any in-bound traffic that
matches the classifier set for that QoS policy. The in-profile action can be any one of the following:
• Drop the packet.
• Set the packet’s DSCP bits to a number between 0 and 63.
• Set the packet’s ToS precedence to a number between 0 and 7.
• Set the packet’s CoS priority to a number between 0 and 7.