1 QSG ti-Series Laser Ver 2.5
ti-Series Laser Quick Start Guide
Caution
Correct
Caution
Do not use any tting
or anything on the
side to lift the laser as
damage can occur.
Caution! Unpacking the wire harness incorrectly can lead to damage.
Keep All specially designed Foam Packaging and end-caps, you will need to re-use it
when re-packaging/moving your laser. Refer to this guide and the Technical Reference
chapters in the laser’s Operation Manual when re-packaging for shipping and/or reloca-
tion. Hint-if laser doesn’t re-seat into the foam easily, try ipping it around 180 degrees.
If you discover shipping damage, document the damage (photographically if possible), then immediately
notify the shipping carrier (responsible party) and SYNRAD. After unpacking, review the Inventory list in the
Intro section within the operators manual.
If you need a replacement box for packing and/or shipping your laser, contact us.
Caution! When re-packing the laser for relocation or shipment, nothing can be on the sides of the
laser at any time as damage will occur. There is only one way the laser ts into the foam! All components
must be stowed under the laser. Re-package the wire harness as shown in this guide. The wire harness
&/or ports can be damaged in shipping if not re-packaged as shown in this guide, the drawings, operation
manual, and/or resources located in our website.
Caution
Possible
Equipment
Damage
Mounting feet and/or rails are optional, for complete details, refer to the laser’s Operator’s Manual and
drawings and Mounting Quick Start Guide located on our website.
Important
Note:
See your Marking Head (If utilized) and the laser’s Operators Manual for complete installation details and
instructions.
Read all Danger, Warning, Caution terms, symbols, and instructions located in the (Laser
Safety Hazard information) sections in the Laser’s Operation Manual and in our Laser Safety/Compliance
101 on our website.
Laser Unpacking:
To Next Page
Need help?
General
