机床产品/Machine Tool Products – 60CA/60CB Simple-Type Wood Cutting Machine Operation Manual
How to Operate 60 Series Controller– 105
•
•
•
•
•
•
•
5 How to Operate 60 Series Controller
5.1 System Status
5.1.1 Not Ready
System cannot implement any operation under Not Ready state.
Conditions:
Emergency stop button is pressed
Serious alarm happens
System will switch to "Not Ready" state from any state and stop all actions to ensure the safety of users and
machine.
5.1.2 Ready
System can implement all operations under Ready state.
Conditions:
"Emergency stop" button is released and no alarm exists, system will switch state from "Not Ready" to
"Ready".
Under "Busy"/ "FeedHold"/ "B-stop" state, if user presses "Reset", system will switch to "Ready" state.
5.1.3 Busy
System is executing NC program.
Conditions:
Under "Ready"/ "FeedHold"/ "B-stop" state, if Cycle Start function is triggered; system will switch to
"Busy" state.
5.1.4 Feed Hold
System pauses the motion of the machine while executing NC program.
Conditions
Press Stop (or FeedHold) button under "Busy" state, system will switch to "Feedhold" state.
Note:
Spindle will keep rotating under "Feedhold" state.
5.1.5 B-stop
System pauses the motion of the machine at the end of the block in NC program.
To Next Page
Loading...
Need help?
General
