Syntec 60CA - Page 115

机床产品/Machine Tool Products – 60CA/60CB Simple-Type Wood Cutting Machine Operation Manual
How to Operate 60 Series Controller– 115
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Finish alignment.
Tool No. Setting
This Chapter will describe how to set the tool No.
Purpose:
We need to confirm the relation between Tool No. and real tool in order to change tool correctly.
Condition:
Both Auto mode or Manual mode are OK..
Operation Method
Tool Set→Tool No.
You will see the table about Tool No. and Tool MG.
MG5—T = 7 means we install tool No.7 at Tool case No.5
This table will renew during change a new tool.
Time to Modify
First initialized when it is made from factory.
Need to confirm the MG No. and T No. Manually when it is disordered.
Tool Manager Function
Purpose:
Record the status of all cutting tool on machine, make users know whether cutting tool reached to Max.
Life, avoid machining in case cutting tool is broken. This function needs a related PLC setting. In case,