机床产品/Machine Tool Products – 60CA/60CB Simple-Type Wood Cutting Machine Operation Manual
Fenu and System Introduction– 36
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
USBDisk
DiskA
Network
USBDisk2
Left column shows data structure of the outer device.
Right column shows data structure of the inner storage of the controller.
Sub-function Explanation
Copy: Copy the remarked file from the outer device to the controller.
Select: Select or deselect each file. (Not available for folder)
Select All: Select all files.
Cancel Select: Deselect all files.
Device Change: Change outer device selection.
Operation Method
Press F1「File Import」, a dialog box will appear.
Default outer device is USB Disk.
If you want to change the outer device, press F5「Device Change」,switch the cursor to the desire
device and press【Enter】, then the left column data structure will change and show the data
structure of selected device.
Use【↑】【↓】to select file.
Move the cursor to the import file and press F2「Select」or 【Space】to remark file.
After remarked all of the import file, press F1「Copy」then all of the remarked file will import into
controller.
File Export
Command
5 Buttons type: F2 Program→F4 File Manager→F4 File Transfer→F2 File Export
8 Buttons type: F2 Program→F8 File Manager→F4 File Transfer→F2 File Export
Function
Export file within controller to outer device.
Function Page Explanation
The upper block shows the outer devices selection with the following choice.
USBDisk
DiskA
Network
USBDisk2
Left column shows data structure of the outer device.
Right column shows data structure of the inner storage of the controller.
Sub-function Explanation
Copy: Copy the remarked file from the outer device to the controller.
Select: Select or deselect each file. (Not available for folder)
Select All: Select all files.
Cancel Select: Deselect all files.
Device Change: Change outer device selection.
Operation Method
Press「File Export」, a dialog box will appear.
Default outer device is USBDisk.
To Next Page
Loading...