Syntec 60CA - Page 98

机床产品/Machine Tool Products – 60CA/60CB Simple-Type Wood Cutting Machine Operation Manual
Fenu and System Introduction– 98
•
•
•
•
•
•
•
•
•
•
•
•
•
Reset all parameters to default.
Note
The setting only takes effect after reboot
My Favor
Path
5 key, 8 key: F5 Maintain → F5 Sys. Setting → F8 Set MMIConfig → F6(F7, F8) My Favor
10+8 key: G5 Maintain → F5 Sys. Setting → F8 Set MMIConfig → F6(F7, F8) My Favor
Explanation
For 8 key system of ARM controller, provides user-define function to F6/F7/F8 of first fenubar layer
Operation Method
Move the cursor with【↑】【↓】【←】【→】to choose the page to set as My Favor and press F1.
Note
The setting only takes effect after reboot
Valid version: 11/21 series above 2.2.0