SYSMEX KX-21 - Page 146

QUALITY CONTROL
5-16 Sysmex KX-21 Operator’s Manual -- Revised October 1998
(13) When the built-in printer is specified for the output device, the set data (mean) is
printed on the built-in printer.
No. QC01
Date 31/12/97 10:02
Mode QC
WBC 7.4 ×10
3
/µL
RBC 4.51 ×10
6
/µL
HGB 14.8 g/dL
HCT 35.9 %
MCV 79.7 fL
MCH 32.7 Pg
MCHC 41.1 g/dL
PLT 208 ×10
3
/µL
LYM% 27.2 %
MXD% 13.4 %
NEUT% 59.4 %
LYM# 2.0 ×10
3
/µL
MXD# 1.0 ×10
3
/µL
NEUT# 4.3 ×10
3
/µL
W-SMV 56.3 fL
W-LMV 172.4 fL
RDW-CV 11.4 %
RDW-SD 27.4 fL
PDW 8.3 fL
MPV 9.1 fL
P-LCR 14.8 %
Figure 5-2-22: Example of Printing
NOTE: • Printin
g
in QC settin
g
s is valid onl
y
when the "Built-in Printer" is
selected. For detail, refer to
Chapter 10, Section 5: QC Settin
g
s .
• This print format cannot be chan
g
ed since it is the special format for QC
anal
y
sis.
(14) When the serial interface (option) is incorporated, set data (mean) is output to the host
computer.
NOTE: • Transmission to the host is valid onl
y
when the "Host Output" is
selected. For detail, refer to
Chapter 10, Section 5: QC Settin
g
s .
• As to the host output format, refer to
Appendix B: Technical Information .
Sysmex KX-21 Operator’s Manual -- Revised January 2000