SYSMEX KX-21 - Page 271

INSTRUMENT SETUP
10-18 Sysmex KX-21 Operator’s Manual -- Revised October 1998
2) Output Format Settings
Set output format of analysis data to the host computer. This can be selected
from the following two kinds:
Settings Output Format
K-1000 ASCII data is output in the published format.
Refer to Appendix B: Technical Information .
K-DPS Binary data is output for connecting with K-DPS.
Data format is not published.
Table 10-6-2: Output Format Settings
3) Auto Output Settings
Set whether to make auto output to the host computer or not.
Settings Auto Output
On Auto Output
Off Not Auto Output
Table 10-6-3: Auto Output Settings
4) Baud Rate Settings
Set the baud rate. This can be selected from the following four kinds:
Settings Baud Rate
1200 1200 bps
2400 2400 bps
4800 4800 bps
9600 9600 bps
Table 10-6-4: Baud Rate Settings
5) Data Length Settings
Set the data length. This can be selected from the following two kinds:
Settings Data Length
7 bits 7 bits
8 bits 8 bits
Table 10-6-5: Data Length Settings