SYSMEX KX-21 - Page 272

INSTRUMENT SETUP
Sysmex KX-21 Operator’s Manual -- Revised October 1998 10-19
6) Stop Bit Settings
Set the stop bit. This can be set selected from the following two kinds:
Settings Stop Bit
1 bit 1 bit
2 bits 2 bits
Table 10-6-6: Stop Bit Settings
7) Parity Check Settings
Set the parity check method. This can be set selected from the following three
kinds:
Settings Parity Check
None None
Odd Odd
Even Even
Table 10-6-7: Parity Check Settings
8) Protocol Settings
Set the protocol. This can be set selected from the following two kinds:
Settings Protocol
Class A Class A
Class B Class B
Table 10-6-8: Protocol Settings
9) Transmission interval Settings
Select a transmission interval from the following:
Settings Interval
0 0 second
2 2 seconds
3 3 seconds
5 5 seconds
7 7 seconds
10 10 seconds
15 15 seconds
Table 10-6-9: Transmission Interval