INSTRUMENT SETUP
10-20 Sysmex KX-21 Operator’s Manual -- Revised October 1998
10) RTS/CTS control Settings
Specify whether or not the RTS/CTS flow control takes place.
Settings RTS/CTS control
Refer Allowed
Ignore Not allowed
Table 10-6-10: RTS/CTS control
(9) When the setting of each parameter is completed, press [SELECT] key. The Setting
Change Confirmation message appears.
Change? Cont. Set Cancel
Figure 10-6-3: Setting Change Confirmation Message
(10) Using [ ] or [ ] key, move the cursor to select "Cont.," "Set," or "Cancel."
[Cont.]: Returns to the Host Settings screen. And the setting operation can be
continued.
[Set]: Updates the settings and returns to the Analysis screen.
[Cancel]: Cancels the changed settings and returns to the Analysis screen.
(11) Press [ENTER] key to execute the selected process.
To Next Page
