INSTRUMENT SETUP
10-22 Sysmex KX-21 Operator’s Manual -- Revised October 1998
(6) Using [ ] or [ ] key, move the cursor to select the set parameter. Printer settings can
be made on three parameters.
(7) Using [ ] or [ ] key, select the condition.
The condition changes each time you press the key.
(8) Press [ENTER] key. The content of settings is set and the cursor moves to the next set
parameter.
NOTE: • The settings can also be set when you press [ ] or [ ] key after
changing the content of settings.
1) Connect Settings
Set whether to connect the built-in printer or not.
Settings Connection
Use Connect
Not Use Not Connect
Table 10-7-1: Built-in Printer Settings
2) Print Condition Settings
Set the auto print condition for the built-in printer. This can be selected from the
following three kinds:
Settings Auto Print Conditions
All Data Print All Samples
Abnormal Data Print Abnormal Data Only
None Not Auto Print
Table 10-7-2: Print Condition Settings
NOTE: • Data printed as abnormal data:
• Data in which analysis error occurred
• Data in which noise error occurred
• Data with flags other than Mark Limits
• Data with histogram flag
• Data out of the linearity limit
• For print conditions of QC data, refer to
Chapter 10, Section 5: QC
Settings.
To Next Page
