SYSMEX KX-21 - Page 276

INSTRUMENT SETUP
Sysmex KX-21 Operator’s Manual -- Revised October 1998 10-23
3) Print Format Settings
Set the print format for the built-in printer. This can be selected from the
following three kinds:
Settings Print Format
Type 1 Print 18 parameters + histograms.
Type 2 Print 18 parameters.
Type 3 Print 8 parameters.
Table 10-7-3: Print Format Settings
NOTE: • For print format, refer to Chapter 2, Section 5.2 Printing of Analysis
Result
.
• For print format for quality control, refer to
Chapter 5, Section 2.6:
Execute
X
Control or Chapter 5, Section 2.7: Execute L-J Control .
(9) When the setting of each parameter is completed, press [SELECT] key. The Setting
Change Confirmation message appears.
Change? Cont. Set Cancel
Figure 10-7-3: Setting Change Confirmation Message
(10) Using [ ] or [ ] key, move the cursor to select "Cont.," "Set," or "Cancel."
[Cont.]: Returns to the Printer Settings screen. And the setting operation can be
continued.
[Set]: Updates the settings and returns to the Analysis screen.
[Cancel]: Cancels the changed settings and returns to the Analysis screen.
(11) Press [ENTER] key to execute the selected process.