SYSMEX KX-21 - Page 277

INSTRUMENT SETUP
10-24 Sysmex KX-21 Operator’s Manual -- Revised October 1998
8. PRINT SET VALUES
To backup the set values, all the contents of the settings can be printed by the built-in printer.
How to Print Set Values
(1) Press [SELECT] key on the Analysis screen. The Select Menu screen appears.
(2) Using [ ] or [ ] key, move the cursor to select "6: Settings."
(3) Press [ENTER] key. The Setting Menu screen appears.
*Settings*
1:System Setup
2:Date/Time
3:Patient Limit
4:QC Settings
5:Host Settings
6:Printer Settings
7:Print Set Values
Figure 10-8-1: Setting Menu Screen
NOTE: • "5: Host Settin
g
s" is displa
y
ed onl
y
when the optional serial interface is
incorporated.
(4) Using [ ] or [ ] key, move the cursor to select "7: Print Set Values."
(5) Press [ENTER] key. The built-in printer starts printing all the set values.
NOTE: • If an
y
fault
y
operation occurs, contact
y
our S
y
smex service
representative. Keep the printed contents of the settin
g
s in
g
ood
condition because the service representative ma
y
have to confirm the
contents of settin
g
s.
Sysmex KX-21 Operator’s Manual -- Revised January 2000