SYSMEX KX-21 - Page 287

INSTALLATION
A-6 Sysmex KX-21 Operator’s Manual -- Revised October 1998
5. CONNECT TUBE
5.1 Prepare Reagent
Prepare the reagents and connection kits shown below.
Reagent Part No. Type Part Name Connection Kit
884-0871-1 PK-30L CELLPACK Cubitainer spout kit No. 1 (for 20L)
974-0521-6 SWH-200A STROMATOLYSER-WH Float switch No. 23
5.2 Connect CELLPACK
(1) Prepare the following reagent tube.
Tube Polyurethane 4 mmID × 6 mmOD : 1 pc
NOTE: • Cut the tube to an appropriate length, and connect it.
(2) Connect the diluent (CELLPACK) inlet aspiration nipple behind the unit and the nipple
of the cubitainer spout kit No. 1 with the tube polyurethane 4 mmID × 6 mmOD.
(3) Set the cubitainer spout kit No. 1 to the CELLPACK container.
CELLPACK
Cap
Cubitainer Spout Kit No. 1
Figure A-5-1: Setting the Cubitainer Spout Kit