SYSMEX KX-21 - Page 48

SAMPLE ANALYSIS
2-12 Sysmex KX-21 Operator’s Manual -- Revised October 1998
NOTE: • When entering the sample No. (on the screen of the previous page),
press [C] key first. This will clear the entire sample No. Then, enter a
new sample No.
• In the course of entering the sample No., each time you press [C] key,
one character disappears with the cursor moving to the left.
• A sample No. of a maximum of six digits, comprising numerics and a
hyphen, can be used.
• The hyphen cannot be used at the first or last digit of a number, and
two or more hyphens cannot be entered in succession.
[Example] NG -123
NG 123-
NG 1--23
• Any number beginning with "0" (zero) cannot be entered.
[Example] NG 0123
(3) Press [ENTER] key. This will fix the sample No. and the status becomes Ready,
namely, ready for analysis.
NOTE: • When all sample Nos. are cleared, [ENTER] key is not accepted.
When you attempt to do so, an alarm sounds.
• In the status of waiting for sample No. input ("Not Ready"), press
[SAMPLE No.] or [SELECT] key. The screen returns to the Analysis
screen without updating sample No.