SAMPLE ANALYSIS
Sysmex KX-21 Operator’s Manual -- Revised October 1998 2-13
4. Analyzing samples
• When analyzing samples, always wear rubber gloves. After
completion of work, wash hands with disinfectant. If your hands are
contaminated by blood, etc., infection of bacteria can occur.
(1) Mix the sample sufficiently.
Figure 2-4-4: Mixing the Sample
(2) Remove the plug while taking care not to allow blood scatter.
Figure 2-4-5: Removing the Plug
(3) Set the tube to the sample probe, and in that condition, press the start switch.
Start Switch
Figure 2-4-6: Pressing the Start Switch
WARNING
To Next Page
Loading...
