What to do if the wash basin is overfilled on my System One Washer?
If the wash basin of your System One Washer is overfilled, it could be due to too much solvent being transferred by holding the on/off button, which means the holding tank is too full and overflowed. To resolve this, remove excess fluid from the holding tank and run a distillation cycle to place fluid back into the holding tank.
Why is my System One Washer beeping?
If your System One Washer is beeping, it might be because the fluid level is low, possibly due to solvent removal. Try replacing or returning the solvent to the unit.
What to do if the recycle process is not starting on my System One Washer?
If the recycle process isn't starting on your System One Washer, wait for one hour if the unit just completed a cycle, as the unit has a one-hour lockout. Also, check the power cord connection and the outlet/circuit breaker to ensure they are properly connected and functioning.
How to fix a System One Washer with wash pump not running?
If the wash pump of your System One Washer is not running, try the following: 1. Press the on/off button. 2. Check the power cord connection. 3. Check the outlet/circuit breaker.
Why does the vacuum pump on my System One 501 sound louder than normal?
If the vacuum pump on your System One Washer sounds louder than normal, check for any debris underneath the unit and rebalance it. If the distillation chamber is overfilled, remove the excess fluid through the drain knob and press the technician override button to restart the distillation.
What to do if there is solvent in the distillation chamber of my System One 501 Washer?
If solvent is present in the distillation chamber of your System One Washer, it may be because the cycle stopped before completion. You can either continue the distillation without transferring fluid from the wash basin by pressing the technician override button, or you can press the recycle button to run a new distillation.
What to do if the wash pump runs but there is no solvent flow in my System One 501?
If the wash pump runs but there is no solvent flow in your System One Washer, check for a low solvent level by removing the strainer basket. Additional solvent may need to be transferred to the wash basin. Press and hold the on/off button for twenty seconds. Repeat if necessary.
How to fix solvent not staying in wash basin of System One Washer?
If the solvent does not stay in the wash basin of your System One Washer, remove any debris around the pneumatic cylinder located under the wash basin false floors.
Key safety guidelines, MSDS, first aid, fire fighting, accidental release, and solvent handling instructions.
Guidelines for unit placement, environment, grounding, and power connection for safe operation.
Instructions on solvent use, fusible link, handling hot parts, and general usage precautions.
Details on authorized service, risk of injury, and warranty voiding due to modifications.
Visual guide identifying key parts like fill plug, recycle button, and drain knob.
Power requirements, environment, capacity, and physical dimensions for the unit.
Information on approved solvents and product certifications (ETL, UL, CSA).
Steps for unboxing, attaching bracket, connecting power, and filling the reservoir.
Detailed instructions for performing the wash operation, including safety and control usage.
Procedure for recycling dirty solvent, including distillation and residue handling.
Solutions for common problems like pump not running, no solvent flow, and recycle process errors.
Details on warranty coverage, repairs, environmental responsibilities, and limitations.
General| Brand | System One |
|---|---|
| Model | 501 |
| Category | Washer |
| Language | English |
To Next Page
