What to do if the wash basin is overfilled in my System One S Series?
If the wash basin of your System One Washer overfilled, this could be due to too much solvent being transferred into the wash basin by holding the on/off button, or because the holding tank is too full and overflowed into the wash basin. To resolve this, remove excess fluid from the holding tank and run a distillation cycle to place fluid back into the holding tank.
Why is the LED flashing green or blue on my System One S Series Washer?
If the LED on your System One Washer is flashing green or blue, it indicates that the fluid level is low. You should add 15 gallons of fluid directly to the holding tank.
How to troubleshoot a wash pump that is not running on a System One S Series?
If the wash pump of your System One Washer is not running, try the following: - Press the on/off button. - Check the power cord connection. - Check the outlet/circuit breaker.
Why does the vacuum pump sound louder than normal on my System One S Series?
If the vacuum pump of your System One Washer sounds louder than normal, the distillation chamber may be overfilled. Remove excess fluid through the drain knob and press the technician override button to restart the distillation.
What to do if solvent does not stay in the wash basin of System One S Series?
If solvent does not stay in the wash basin of your System One Washer, remove any debris around the pneumatic cylinder located under the wash basin false floors.
What to do if the wash pump runs but there is no solvent flow in my System One Washer?
If the wash pump of your System One Washer runs but there is no solvent flow, check for a low solvent level by removing the strainer basket. Additional solvent may need to be transferred to the wash basin. Press and hold the on/off button for up to sixty seconds. Repeat the procedure if necessary.
What to do if there is solvent in the distillation chamber of my System One S Series?
If you find solvent in the distillation chamber of your System One Washer, it's possible the cycle stopped before completion. Press the technician override button next to the power cord to resume the distillation process.
What to do if the recycle process is not starting and LED is flashing yellow three times on my System One S Series?
If the recycle process is not starting and the LED is flashing yellow three times on your System One Washer, drain oil from the distillation chamber. Then, reset the machine and start it again.
Keep manual accessible, read MSDS, observe warnings, and follow first aid procedures for safe operation.
Proper spacing from ignition sources and grounding are required for safe installation and operation.
Follow safety warnings for solvent use, lid operation, part handling, and cleaning to prevent hazards.
Service must be performed by authorized technicians; modifications void the warranty.
Details power requirements, environmental conditions, and dimensions for different models.
Lists approved solvents and cautions against using unstable reactive solvents like Nitrocellulose.
Indicates the unit is ETL listed and conforms to relevant safety standards for solvent distillation units.
Instructions for attaching brackets, connecting power, filling solvent, and initial checks before operation.
Steps for operating the wash function, including safety gear, lid use, part cleaning, and draining.
Process for transferring dirty solvent to distillation and returning clean fluid, including residue draining.
Guide to setting the current time and day on the automatic timer unit.
Instructions for switching between automatic and manual operation modes for the timer.
Details on creating, modifying, or deleting automated recycling schedules for the unit.
Covers defects, performance, limitations, exclusions, and disclaimer of implied warranties.
Addresses waste disposal responsibility and sole source affidavit for equipment.
General| Brand | System One |
|---|---|
| Model | S Series |
| Category | Washer |
| Language | English |
To Next Page
