P/N: 60400601
REV: 02/04
8
Problem Solution
Press on/off button.
Check power cord connection.
Check outlet/circuit breaker.
Wash pump not running
Contact customer service.
Check for low solvent level by removing the strainer basket.
Additional solvent may be transferred to the wash basin. Press and hold
the on/off button for twenty seconds. Repeat procedure if necessary.
Wash pump runs
but no solvent flow
Contact customer service.
Wait for 1 hour if unit just completed a cycle. Unit has a 1 hour lockout.
Check power cord connection.
Check outlet/circuit breaker.
Recycle process not starting
Contact customer service.
Cycle may have stopped prior to completion.
Option 1: Distillation can be continued without transferring fluid from the
wash basin by pressing the technician override button.
Option 2: Press the recycle button to run a new distillation.
Solvent in distillation chamber
Contact customer service.
Remove debris around pneumatic cylinder located under the wash basin
false floors.
Solvent does not stay in
wash basin
Contact customer service.
Check for debris underneath the unit and rebalance it.
Distillation chamber is overfilled, remove excess fluid through the drain
knob and press the technician override button to restart the distillation.
Vacuum Pump sounds
louder than normal
Contact customer service.
Too much solvent was transferred into the wash basin by holding the
on/off button.
Holding tank is too full and overflowed into the wash basin. Remove
excess fluid from the holding tank and run a distillation cycle to place fluid
back into holding tank.
Wash basin overfilled
Contact customer service.
Fluid level is low due to removal of solvent to remote locations. Replace or
return solvent to unit.
Machine is beeping
Contact customer service.
TROUBLESHOOTING
To Next Page
Loading...
