23
Freshman Series - Owner's Manual - Installation, Operation, and Service Instruction - Version 1.1 EN
Exterior Louver
Wall Sleeve Assembly
A. Wall Sleeve with a divider
for relief air
6.6 Figure 11 | General Wall Sleeve Assembly
6.7 Exterior Louver
The exterior louver is supplied with the unit and should slide into the wall sleeve
from the outside of the building. Fasten to the wall through the standard 2” ange.
Refer to Information Package and installation diagrams shipped with the unit.
(screws not provided)
NOTE:
Two condensate drain
lines exit through the
back of the unit and are
supported by the exterior
louver.
was sent with the Unit for exact measurements, descriptions and installation details.
B. Wall Sleeve for standard
ventilation
Wall Sleeve Assembly
Installation Guide
To Next Page
Loading...
