Instructions for unloading on the site as well as installation and connection |
19
Place the strap on the bottom profiles of the unit to avoid any load and stress on the vertical profiles when sections are
pulled together along the base frame. The sections must be pulled fully and tight together with the strap is placed on
the bottom profiles. Do not pull and slide a section unless the strap is placed on the bottom profile.
When the sections are pulled fully together it may be helpful to place the strap halfway up on the unit to press the sec-
tions fully together so that the rubber seals are closing 100% tight. Only gentle tension is allowed because the vertical
profiles are not reinforced for brutal stress in this direction and they may be bent.
output |
To Next Page
Loading...
Need help?
General
