EasyManuals Logo

SystemAir SysAqua 25 User Manual

SystemAir SysAqua 25
80 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
English
20 SysAqua
11.2.2. WIRING DIAGRAM KEY DESCRIPTIONS
11.2.2.1. POWER SUPPLY DIAGRAMS
11.2.2.2. CONTROL AND REGULATION DIAGRAMS
QG : main section switch
KA1 : three-phase network control relay (phase sequence and cut-out)
FT1/2 : M1/2 compressors magneto-thermal circuit breaker
K1/2 : M1/2 compressors power circuit contactor
M1/2 : compressors 1 and 2
R1/2 : M1/2 compressors crankcase heater
FTC : control circuit magneto-thermal circuit breaker
FTOF-L : outdoor fans magneto-thermal circuit breaker
FTOF-H : outdoor fans magneto-thermal circuit breaker
KOF : outdoor fans power contactors
KOF-L : outdoor fans power contactors
KOF-H : outdoor fans power contactors
OF1/2 : outdoor fan motor
S1 : compressor internal safety device 1
PCB : CHILLER regulation
T1 : CHILLER regulation transformer
FT1/2 : 1 and 2 compressors additional magneto-thermal circuit breaker
FTOF-L : outdoor fans additional magneto-thermal circuit breaker
FTOF-H : outdoor fans additional magneto-thermal circuit breaker
FOF1/2 : outdoor fans motors internal protection
FS : ow switch
WPS : water low pressure switch (option)
KHP : high pressure safety relay
HP : automatic reset high-pressure pressostats
K1/2 : M1/2 compressors power circuit contactor
RAG : antifreeze electric heater
RV1 : 4-way cycle changeover valves (option)
KA1 : three-phase network control contactor
FPE : pressure transducer (low pressure)
FPC : pressure transducer (high-pressure)
OCT : de-icing temperature probe
OAT : outdoor temperature probe (air)
CDT : high discharge temperature probe
EWT : inlet water temperature probe
LWT : outlet water temperature probe
S1 : compressor internal safety device 1
SM1 : ON/OFF switch
SD/N : switch day / night (not supplied)
SS/W : switch summer / winter (closed in winter) (not supplied)
11.2.2.3. OPTION PUMP
WP1 : water pump
KWP1 : water pump motor power contact (option)
FTWP : water pump motor magnetothermal circuit breaker (option)
11.2.2.4. OPTION DUAL PUMPS
WP2 : water pump
FTWP : water pump motor magnetothermal circuit breaker
KWP2 : water pump motor power contact
SWP : selector of pump 1 or 2

Table of Contents

Other manuals for SystemAir SysAqua 25

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the SystemAir SysAqua 25 and is the answer not in the manual?

SystemAir SysAqua 25 Specifications

General IconGeneral
BrandSystemAir
ModelSysAqua 25
CategoryHeat Pump
LanguageEnglish

Related product manuals